M14 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
4,689 Posts
I have several Webley and Enfield revolvers in my military pistol collection including a Royal Irish Constabulary. I compared your picture to my Webley Mark VI and it appears very similar, including the slight bend in the firing pin. Open your pistol, then the hammer and lower it while holding the trigger to the rear and see how far the firing pin protudes past the face of the breech.

Will your firing pin pass through the breech face and protrude around .25 - .30 thousandths or so? Or does it hang up on the inside of the breech face and not go past the breech face? If that is the case, then some idiot has bent the firing pin and you might gently try to straighten it by trial and error that is if you can't find a new replacement hammer.

7th
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top