M14 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
160 Posts
Discussion Starter · #1 ·
Having the best wife in the world and her setting me up for a birthday present with a Al Story Barrel Vice, i have to ask you guys.

I've always used a vice with wooden blocks, but the Story has aluminum bushings. It comes with a 1.250 dia..

What bushing do i need for M14's, Garands, M1 Carbines and AR's?

I'm thinking about a 1.10 for M14's.. would that be right?

Thanks for the info. Can't wait to get this and use it on my Bula Builds..
 

·
Registered
Joined
·
1,096 Posts
BEST VISE for barreling. You are correct 1.10" is what you need for M1&M14 barrels. Grab the barrel right at the barrel shank. I use rosin powder& 1 wrap of newspaper the width of the blocks. Level up front sight base tighten down center screw of VISE and you are good to go. I use an old Rem 700 barrel as a cheater for tightening. Plus Al is a great guy and last time I chatted with him he has working on a action wrench with inter changeable heads for different actions.
Pfc out
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top