[HK-91]

I'm looking to buy metal SR 25 mags for my Galil ACE. So far I bought a CSpecs which seems well made and fits and has functioned well for 80 rnds. I just got a DPMS yesterday but haven't used it yet. It too seems well made, though a little different in construction, have tried it in the gun and fits and drops out well full or empty. Some advice I got from another forum said stay away from ProMag that they aren't that good. So while looking for better prices for DPMS mags I find that DPMS (Panther Arms) are made by ProMag. Now I'm confused. I get a recommendation for DPMS and against ProMag but find out ProMag apparently makes DPMS. Can anyone help me out here figure this out? What can I get for a good reliable steel mag that doesn't cost $100 (KAC). I want to have 20-30 mags which is just policy for my rifles but haven't got a clue as of now which are worth the investment. Any help on this would be greatly appreciated. Thanks in advance.

 

[noob14s]

Just get a dozen pmags and be done with it.

 

[HK-91]

Just get a dozen pmags and be done with it.

I may wind up with some eventually, but, right now my preference is steel mags.

 

[dsdmmat]

All of my steel mags are DPMS mags. That being said I use a lot of Pmags in my AR308s

 

[Rutlege]

What about Lancer? I know they are polymer but they do have metal feed lips. I've been running the 5.56 version in some classes and in/around the range - so far haven't had any issues.

 

[Bamban]

I have a few KAC SR25 steel mags, some are new, make me an offer, OP. Send me a PM.

 

[HK-91]

I have a few KAC SR25 steel mags, some are new, make me an offer, OP. Send me a PM.

PM sent.

 

[Grizzman]

Are the current C-Products mags any good? I bought a couple of them a long time ago, and they've worked reat. My DPMS mags needed some feed lip tweaking for 100% reliability.

Once PMAGs were introduced, I didn't buy any more metal ones.

They're not cheap, but LaRue sells them also. I'm not sure if they make them in-house, or have them made for them.

 

[HK-91]

Are the current C-Products mags any good? I bought a couple of them a long time ago, and they've worked reat. My DPMS mags needed some feed lip tweaking for 100% reliability.

Once PMAGs were introduced, I didn't buy any more metal ones.

They're not cheap, but LaRue sells them also. I'm not sure if they make them in-house, or have them made for them.

The C Products test mag I bought worked fine for 60 rnds so far. The DPMS is sitting loaded on the table waiting for it to stop raining so I can test it out. What kind of "tweaking" did you have to do to yours?
It came with a PMag and it works fine, I just prefer steel.

 

[Grizzman]

It's been 9 years, but If I remember correctly , I needed to spread the feed lips to raise the height of cartridge.


Sent from my iPhone using Tapatalk