M14 Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
215 Posts
Discussion Starter #1 (Edited)
UPPER RECEIVER ASSEMBLY ONLY!

Selling a fantastic XM177 retro build that I just finished. Other priorities have come up and it's got to go. This is a complete upper with charging handle and bolt carrier group (BCG).
Specs:
Upper - Fulton Armory A1 with all new USGI parts and M4 feed ramps
BCG - M16 phosphate carrier with nickle boron 9310 steel bolt and chromed firing pin
Barrel - Brownell's 12.7 inch retro pencil barrel with chrome lining chambered in 5.56 NATO. Correct non F-marked front sight without bayonet lug and Brownell's XM177 flash hider with grenade ring. 1/7 twist. Feed ramps blended to match upper receiver. With flash hider the barrel measures just over 16 inches long. If you pin and weld this flash hider then you can put any stock with this upper that you want. If you don't pin and weld the flash hider then you have to use it on a pistol lower or register it as a Short Barreled Rifle.
Handguards - Vintage 6 hole units with aluminum liners. Not sure of make but I had to clean them up and they fit nice and snug compared to others out there.

Comes with one Brownells milspec 20 round magazine.
It has been function fired with about 25 rounds of FMJ and soft point ammo. Function was 100%.

SOLD!
 

Attachments

·
Registered
Joined
·
215 Posts
Discussion Starter #6
I might consider trades for the following:
-Long slide 40 caliber handguns
-40 cal defensive ammo
-5.56 fmj
- need a couple good quality 1911 govt mags
 

·
Registered
Joined
·
215 Posts
Discussion Starter #8
Also interested in 1911s, Glock 23 9mm conversion barrels, or S&W revolvers.
 

·
Registered
Joined
·
215 Posts
Discussion Starter #9
Open to other offers. Sig P220s, 10mm pistols. Make some suggestions.
 
1 - 10 of 10 Posts
Top