M14 Forum banner
1 - 2 of 2 Posts

· Registered
289 Posts
Discussion Starter · #1 ·
Hello All,

I am checking over everything before I assemble my M39ish build. I was fortunate to get the USMC rings and a SIMRAD cap for the front. I was roughly putting together the scope/rings/base to see where I wanted everything. I was curious if I am perhaps tightening the screws wrong (not torquing yet just seeing where I want it all still) but the ring with the simrad cap and the Badger screws will not attach due to what I believe is short screws. Are there longer screws that should go with a SIMRAD cap? Thanks
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.