M14 Forum banner
1 - 3 of 3 Posts

·
Banned
Joined
·
951 Posts
Discussion Starter · #1 ·
Just installed a Sadlak steel mount ok my m1a, installed per instructions, mount seem per specs. Have a new bushnell 3200 mil dot 10X, leupold Med QRW rings. Trouble is the rifle shoot low (24 inch low) at 25 yds. Elevation walks the point of impact to a 25 yard 0 BUT the elevation is all wound up to the 500 yard line. I took the mount apart several times, re-did the install per Sadlak instructions...same deal. Any Ideas??????????????USAF2
 

·
Premium Member
Joined
·
18,086 Posts
Check the screw that touches the front of the receiver. Could be that it is applying too much upward pressure on the mount thereby raising the front of the scope. I have used the same mounts with great success. Good luck. Nice product when it works.
Art
SGT USMC 66-72 RVN 67-68
Semper Fi
 

·
Premium Member
Joined
·
1,091 Posts
Don't hesitate to give us a call at 860-742-0227 Ext 14 for assistance with the install and any questions you might have about problems.
 
1 - 3 of 3 Posts
Top