M14 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,848 Posts
...So, here's my question. Can I simply elongate that hole in my mount to allow a proper fit? The only other alternative is to fill the hole and re-drill. Any thoughts? By my estimation, the mounting screw does nothing for alignment but only secures the mount to the receiver.

Any thoughts greatly appreciated.
Many mounts already come with some kind of bolt hole elongation so that the mount can be moved front to back to adjust for variations in stripper clip guide dovetail positioning. You'd just be adding adjustability to the mount, albeit up and down rather than front to back, so go for it! GI2
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top