M14 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
131 Posts
Discussion Starter · #1 ·
I finished my build, all went well and now I have a minor problem. The screw at the 12 oclock postion at the front that reduces barrel whip will not screw down to barely touch the barrel. Man, after I backed off the set screw and attempted to adjust this screw, it got tighter than hell and liked about a little over a 1/16th to touch the barrel. I wonder why this is so damn tight? You would have thought you could adjust it, then tighten the set crew at the 3 oclock postion to lock the adjustment. Any ideas? Thank you in advance.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top