M14 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
Hi folks.

Is it normal to maybe have to lightly sand or file down the part that fits in the stripper guide? Mine is too snug and I am afraid if I tap it in it might get stuck permanently. I tried it a bit and rubbed the park off the sides that went in...

nemethm
 

·
Registered
Joined
·
20 Posts
Discussion Starter · #4 ·
Do you have the set screw sticking out too far??

no...it was just really tight on the sides and wouldn't even insert w/o a hard knock. I polished it down on the sides a bit then tapped it in..it's tight but at least it won't slip. If I take it off I suppose I'll need to go thru the bottom of the action and tap it out with a punch. It was a SAI receiver/ stripper guide FYI

m
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top