M14 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
4,793 Posts
Discussion Starter · #1 ·
Mr. Wolfe,
A few years ago I had SEI do a max pack trigger job on the trigger group out of my SAI M21. This was before I was aware of your services, and before I learned of SEI's lack of support.
Anyway, I am happy with most of the trigger job. I replaced the hammer, trigger/sear, safety, and trigger guard with usgi parts before sending to them for the trigger job. I asked for the hammer spring housing and plunger to be replaced with usgi parts as I did not have those parts. For whatever reason, the housing and plunger did not get replaced.
Can I just swap out the parts with good condition usgi parts and not mess up the feel of the trigger group? Or are those parts usually modified or polished during the max pack trigger upgrade? Thanks for your time and help.
 

·
Registered
Joined
·
1,163 Posts
I have no knowledge or experience with the trigger group modification you describe. Any swapping of parts after a trigger job has the potential to change the trigger performance.

You should discuss this question with the company that performed the service.
 
1 - 3 of 3 Posts
Top