M14 Forum banner
1 - 1 of 10 Posts

· Registered
36 Posts
Unitizing Gas Cylinders

I've been monitoring this thread regarding the 2 screws method. And for the past 3 gas cylinders, I've always had them MIG welded. Great results, too. :D

What am I missing ?? Is the welding technique not recommended ?? Any enlightenment would be appreciated. :roll:

Thanks, :wink:
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.