M14 Forum banner

Prestine Heel Stamped Polytech

3085 Views 19 Replies 10 Participants Last post by  garandguy10
5
I have been trying to find the somewhat rare but becoming more rare "Rear Heel Stamped Polytech" I ran into a decent deal for what I thought was a moderately used heel stamped Polytech M14S. To my surprise the barrel is in unfired condition as well as everything else. The bolt face didn't even have a ring around the firing pin. So long story short I snagged the rifle ASAP. It has a USGI synthetic stock on it and a neutered flash hider that I am not sure are original to the rifle. It did come with a 30 or 40 round magazine (it is huge) that I will probably throw on PX. It also came with a USGI cleaning kit in the butt of the rifle. The beginning of the year seems to be the best time to shop. This is hands down the best looking Chinese M14 I have ever seen. And my 8th M14 of my collection sitting rightfully next to my other Poly and my heel stamped Norinco. M14 #9 is already in the works and will be my first personally built rifle. Looking like a good start to the year for me.









Dont mind the grease it has been cleaned up. It was somewhat excessively slathered on.

See less See more
  • Like
Reactions: 3
1 - 1 of 20 Posts
I have a few early heel stamped Chicom M14'S. Headspace tends to be too tight on a few of mine. I would recommend confirming headspace and bolt lug contact. Heel stamped Chicom M14's tend to take USGI bolts with little lapping and no breech shroud interference.
1 - 1 of 20 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top