M14 Forum banner

Pre primed brass

1K views 5 replies 5 participants last post by  33rdsignal 
I have some Federal "08" NATO primed brass that was "pulled" from Treadstone Ent.. Looks like someone at Federal got crazy with the neck sealant. I wire brush the sealant out of the necks and reshape the neck with my die.(remember to remove the decapping pin.) I do not resize the shoulder I only go down enough to round the necks out.
I have not had any problems with them, so you should be good to go.

Glenn
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top