The 4th Gen Steel Mount is made to about the same specs as a SADLAK or Smith Enterprise mount. I think the biggest issue with these mounts is that people have a hard time reading the instructions. If its canting off to the right theres a good chance you are cranking the front contact screw down too far which will cause the mount to flex. My advice. Take the mount back off and then carefully follow the instructions and reinstall it.
To prevent it from coming loose you need to make sure the cam has pressure against the reciever bolt after the reciever bolt is finger tight. Then tighten the reciever bolt down a good 1/4 turn or so.
To prevent it from coming loose you need to make sure the cam has pressure against the reciever bolt after the reciever bolt is finger tight. Then tighten the reciever bolt down a good 1/4 turn or so.
