M14 Forum banner

NM Trigger groups.

980 Views 11 Replies 6 Participants Last post by  warbird
Just wondering where I can purchase a NM trigger set(2 stage?) for my Polytech M14. And would this be a drop in replacement?


Thanks.
1 - 1 of 1 Posts

· Registered
Joined
·
1,015 Posts
hey timanator,
i had my local m14 smith do a nm job on my poly trigger group and it is the cleanest,crispest 4 1/2# pull i have ever felt.the only thing i did was replace the hammer with a gi one.i read somewhere that chicom hammers can be a little soft ???.other than that the chicom's are fine and will tune very well.i agree with above posts,have warbird so a nm job on it.....good luck..glock
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top