[Alvin55]

Hey Guys,
I have an AR that needs a longer pin for the hole near the mag well. I have picture of both sides and you can see the pin does not go through. I have 4 AR's and have never seen this before. Can anyone tell me where to get longer pin and what in the world is going on.
With Respect,
Alvin

 

[Wasted ammo]

Is that lower polymer?

 

[Capona]

The pics seem grainy on my iPhone.

What is the upper and lower?

 

[Alvin55]

Thank you guys for your help! I have seen dia. differences but never length diff.
It is a steel receiver and is made by Diamond. I have looked everywhere but only only find different OD pins
Thanks for your time and help in this matter,
Alvin

 

[Wasted ammo]

Contact the maker of the receiver.

 

[Alvin55]

Thank you, I will do that.
Alvin

 

[noob14s]

If you mean the pin for the hammer you could use a regular one or you'll need a longer anti-walk one.

 

[Wasted ammo]

That lower was built about 65 miles from my home. 803-442-9206 is their number.

 

[hardheaded]

I have whittled pins using the proper diameter drill rods and HSS pins from MSC grooving with a lathe or dremmel

 

[Merle]

If its a standard pin and mil spec type hammer it doesn't matter if it is completely flush on the exterior of the lower because the J spring in the hammer captures the pin by engaging into the groove in the middle of the pin.