M14 Forum banner

Nailed it! Shooting Sight's new EBR profile match-grade trigger

4627 Views 26 Replies 17 Participants Last post by  Freddahead
I got a package in the mail yesterday and in it was a brand new fully-adjustable trigger specifically designed to be used in pistol-gripped M14's. It dropped right in and all I can say is WOW!!!

You get a lot more trigger than a GI trigger...

Here's an illustration about the current issue that a GI profile trigger presents with pistol-gripped chassis systems. The trigger finger is not fully supported and it causes discomfort during extended shooting sessions

Here's the Shooting Sight extended trigger. It presents not only a longer trigger which fully supports the trigger finger, but it's set at a different angle thats' more ideal for pistol-gripped rifles as well.

Up until now, the only solution was the trigger shoe which was installed using two set screws which clamped on to a GI trigger.

I tested the trigger out on a traditional stocked rifle as well and it is still comfortable and the angle that it's set at doesn't seem to take away from the original design.

Admittedly, I didn't read the instructions before diving into installation, but I was able to adjust the trigger pull to an obscenely low and then adjust it back to the proper trigger pull. Setup was probably in the instructions but I was just too excited to read them.

See less See more
  • Like
Reactions: 5
1 - 1 of 27 Posts
Looking GREAT! I can't wait to get one.
It was a pleasure helping you and trying out a couple different plastic profiles. It is so neat to see a need or idea go from mind to an actual high quality product.
  • Like
Reactions: 2
1 - 1 of 27 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.