M14 Forum banner

mia parts

1233 Views 2 Replies 3 Participants Last post by  ripsaw
I need a connector lock @ pin -usgi
1 - 1 of 1 Posts

· Registered
423 Posts
If it is the little roll pin / tension pin that holds the piece in the gun, skip it. it is not necessary except to keep the piece from falling off the gun and that won't happen if the receiver is in the stock.

If I am not understanding which part you are describing, please ignore this.
- Ivan.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.