M14 Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
2,738 Posts
Discussion Starter · #1 ·
As the topic states, the magazine well gets too tight when I reinstall the trigger. Without the trigger group, the magazine clears the sides like normal. Once I install it, the magazine is too wide for the well.

Any explanation for this? The only thing that has changed about the stock is I applied gun skin on the surface (none inside the stock) and I also installed a NM spring guide.

I switched the rifle to a USGI wood stock to make sure it wasn't just the magazine, but everything worked fine.

Any guesses?
 

·
Registered
Joined
·
2,738 Posts
Discussion Starter · #2 ·
My ONLY guess, and I'm hoping someone has advice before I try this, is that the gunskin is causing extra space between the receiver and the trigger group, making it pull in tighter. The only way to test this is to remove the gun skin, but if that isn't the problem then I just wasted $50.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top