M14 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
244 Posts
Discussion Starter · #1 ·
FYI

I corresponded with Lou about the customer's "hammer hitting the bridge" scenario and he responded as follows:

Tom
We "beefed up" the rear side of the receiver bridge for additional strength (above and beyond the GI prints). On some receivers it was excessive, and required a quick fix with a dremmel. "Problem" has been resolved. Will catch up with you in the future. Lou
 

·
Registered
Joined
·
122 Posts
Hey thanks for talking to Lou about that problem.
I would of done it but I have been busy the last month. I just got my Krieger barrel for a NM LRB build and haven't had the time to go to LRB.

Did Lou say if they will be going back to the specs?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top