M14 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
15,129 Posts
Been there numerous times.

The pads on the bottom of the trigger housing are angled. They actually squeeze the polymer stock a bit when you clamp the trigger guard shut.

When reassembling, insert a magazine before you clamp the trigger guard shut.

You can polish the inside walls of the stock mag well with some CLP and wet/dry sandpaper.

Finally, you can cut some shims from aluminum flashing and glue them inside the stock, where the recesses for the receiver legs are. This will spread the stock a bit when you insert the receiver.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top