M14 Forum banner

I NEED HELP

742 Views 4 Replies 4 Participants Last post by  Jack Stanley
Hey guys,
this is my first time trying to strip my garand and i got the trigger group out and am trying to remove the receiver but i cant seem to get it out. Can anyone help this newbie out?
1 - 5 of 5 Posts
Do you know if the rifle is bedded? They can be hard if it is. If not you can flip it upside down (sights down) and smack the buttstock across your knee a couple times. Should knock it loose. Just hang onto it.
Since it's a CMP rifle, I doubt it's bedded but, just a tight fit.
Once the trigger group is removed just turn it over and tap the butt on your leg and it'll pop right out.

That would be a good time to see what parts ya have on your rifle as well.




See less See more
I got it off

Well i got it off and it sure was a tight fit. It took a bit of elbow grease but i got it. Thanks for your help.
It's a good thing that it's tight , loose enought to fall out when the trigger group comes out is not a good thing .

Jack
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top