M14 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
226 Posts
Discussion Starter #1
Am looking at a rear sight for HRA build project...the elevation knob is marked "WCE" and the windage is marked "Wright"...are those subcontract markings appropriate Or would only straight "HR" markings be correct?

Thanks in advance for yur thoughts.
 

·
Registered
Joined
·
5,679 Posts
Am looking at a rear sight for HRA build project...the elevation knob is marked "WCE" and the windage is marked "Wright"...are those subcontract markings appropriate Or would only straight "HR" markings be correct?

Thanks in advance for yur thoughts.
They'd be correct enough for a M14-type IF the WCE pinion is calibrated in meters not yards. If it goes to 1200 it's for a Garand.
 

·
Registered
Joined
·
2,484 Posts
Found this posted by Different on the www. ebrsopmods.proboards.com boards
-Elevation knob-Wico electric-WCE, made for H&R and TRW and in 1969 as replacement parts.
-Windage knob assembly-Wright Manufacturing-HRA-W, made for H&R.
Wright Manufacturing-WRIGHT- made for TRW.
 
1 - 4 of 4 Posts
Top