M14 Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,538 Posts
Discussion Starter · #1 ·
Why is it on most of my good rifles the rear sights are so poor? I had 3 x's in a row at 600 yrds today, until I had to mess with them :( . Meaning, I add 1/2 min right, and POI moves both right and down 1 min.

So I would like to gage/measure them on the workbench. Using a caliper, micrometer or dial indicator (but nothing special to hold it :( )

Looking for suggestions on what/where to measure as I dial in windage or elevation changes, on the typical M1/M14 rear sight. I guess I should look in my Kuhnhausen manual too!

Thanks
Dave
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top