M14 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,378 Posts
Discussion Starter · #1 ·
I have heard Hawk mention that the right rail on an ArmsCorp receiver is thick enough that he has to modify his dummy kit to accomadate this thickness. My question is, how much thicker is the rail than say a Springfield or Polytech. Entreprise has the thinest rail I've seen.

Regards

Ox
 

·
Registered
Joined
·
3,923 Posts
Oxmix:

I see a difference between the Armscorp and SA receivers. I would have to mic it to actually tell you what the difference is.

Hope Hawk or someone got the answer. If not, I will mic the receivers as soon as possible.

Aloha,

Tom O.
 

·
Banned
Joined
·
10,629 Posts
The thickness of the Armscorp receiver rail is aprox 3/8" where the Springfield is aprox 1/4". The 1/8" difference is about the same as the thickness of the middle section of the connector arm.

""thick enough that he has to modify his dummy kit "" I don't provide this modification unless requested for a nominal charge. Thanks, Hawk
 
1 - 3 of 3 Posts
Top