M14 Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter · #1 ·
Hey there everyone,

I have a pair of hand gaurd pliars for my m1 garand to remvoe the retaining clip, will those same pliars work for the polytech m14. It appears the rear retaining clip has a whole in each end of it. The clips I have wont fit in the hole. I am assuming something goes in those holes to remove the clip. The pair that I have says " strobel " on them.

Any help would be appreciated!

Thanks,

Rchjr
 

·
Registered
Joined
·
2,021 Posts
There is a tool but I just use a thin flathead screw driver between the barrel and the clip, comes right out.
 

·
Registered
Joined
·
1,198 Posts
For me having a Sadlak Mount it was easier to remove the FS and take it off that way but I would think that a flat blade would work without having a mount
 

·
"Death From Above"
Joined
·
11,646 Posts
Same tool as the garand you are good to go. Nothing on my tool fits in the holes. Typically the tool is only used to install the clip on the handguard not the barrel.
 
1 - 4 of 4 Posts
Top