M14 Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
81 Posts
Discussion Starter · #1 ·
What are the hive’s thoughts about this op rod track? Seems that an excessive amount of material was removed at the dismount notch. Would this be concerning or is this something this isnt an issue? I would think the op rod tab could rub against this area over time but i would not know. Thanks in advance!
Grey Wood Auto part Tool Camera accessory
 

·
Registered
Joined
·
15,111 Posts
It doesn't make any sense to remove that much material. A flush notch would be fine. Most have a slight ledge that must be overcome for oprod removal.

This looks crudely done. What is the manufacturer and serial number range?

That being said, it probably won't harm the oprod. It's the bottom part of the tab that wears, not the back.
 
1 - 8 of 8 Posts
Top