M14 Forum banner
1 - 1 of 18 Posts

· Registered
Joined
·
5,799 Posts
I have three uppers, a DPMS, a S&W M&P, and a Palmetto State Armory.

The DPMS has a fantastic stake job done by Ahlman's when they replaced the chattered muzzle finish..

The other two are crap. I assume sending them back will be on my dime, so I think I'll be out over $50 for shipping.

For ~$20 more, Brownells will ship me the tool to do it myself: (69.99 + 3.95 = 73.94)
https://www.brownells.com/gunsmith-...5-m16-carrier-key-staking-tool-prod29337.aspx

If I get it, what are my odds of selling it and getting most of my $$$ out of it?

EDIT: If I sell it for $50, I'm $20 to the better.
I will buy it for $50 shipped, if you decide to go that route. I am supporting a couple of dozens of TX Junior shooters, I am sure at some point I could use the tool.
 
1 - 1 of 18 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top