M14 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
203 Posts
Discussion Starter #1
I am replacing the factory muzzle break on my scout with an SEI Coast Guard break. The factory sight measures .682 from the bottom of the sight to the top of the post. The one on the SEI measures .583 Is this an issue or am I over thinking it?
 

·
Registered
Joined
·
10,897 Posts
The sight that came with your scout rifle is the correct height. You need to put it on the new SEI brake. The one that came with the SEI brake is for a 22" barrel.
 

·
Registered
Joined
·
10,897 Posts
Some folks have been able to use the stanard sight on a Scout, with the rear sight bottomed out, but usually it prints about 8-10" high at 100 yards.
 
1 - 4 of 4 Posts
Top