M14 Forum banner
1 - 1 of 13 Posts

· Registered
60 Posts
I haven't tried the gunkote yet but I have been using their teflon/moly spray for a couple years on pistols.It is a long wearing finish. I have a colt commander that I have shot about 5000 rounds through and the only wear to the finish is on the frame rails.

It is easy to use if you can find an over to bake it in that wont upset your wife. Like any other paint the darker the shade the more imperfections will show up in either the surface prep. or your spraying technique.

I only use it for pistols and small parts so I can bake it in a toaster oven in the garage so it wont stink up the house. It is perfect for and does a fine job on stainless parts like gas cylinders for M14s and Garands.
1 - 1 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.