M14 Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
182 Posts
Discussion Starter · #1 ·
Well,


Brought the newest member of the family home, serial number 510XXX, a standard fiberglass in 308. I installed a LRB NM op rod spring guide, a Tubb spring, for the op rod and trigger. The trigger has a very clean 1st and 2nd stage, and breaks at 4.5 pounds. The rifle passed the tilt test, there was very little play in the front barrel band. But I did shim up the gas system, and the gas cylinder lock is timed right at 530. Took my Bassett mount, mounted it to the rifle, and topped it with Vortex 30mm rings, and installed my SWFA Super Sniper 10x42 MOA scope. Cleaned the barrel, and put a cheek riser on her. See the pictures below! Very pleased! L8899#
 
1 - 4 of 4 Posts
Top