M14 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Has anybody experimented with loads for the SR25 or AR10? I'm planning to go with a Federal Case, Federal 210M Primer, Sierra 168BTHP, and 41.5gr. of Varget. O.A.L 2.800 I use this load in my M1A Super Match and it just rocks with the exception of a Federal Primer I use a CCI 200. Any suggestions out there.
 

·
Registered
Joined
·
3,923 Posts
Aloha Nakas,

Welcome Aboard. That load looks like it should be effective and very close to what I am developing and experimenting with...

The only thing, I might suggest is looking into CCI #34 military primers for the M1A. I don't know whether the SR-25 has a floating firing pin but I suspect it does, and if so, you might consider these primers for that rifle as well.

I bet that recipe if it does well in your SM, should do well in the SR25 at least as a starting point. Good Luck on your quest for the "magic bullet"! I'm looking for it as well!

Aloha,

Tom O.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top