M14 Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter · #1 ·
I,ve been wanting to build a 308 tanker, my question is if I use this kit http://www.e-gunparts.com/itemnumber.asp
an M1A receiver, bolt, and trigger group what other parts would be needed to complete it, and would it fit a GI fiberglass M14 stock? Also if I used a Reese BM59 folder would it would I need the M1A or M1 stock?
Thanks in advance
 

·
Registered
Joined
·
947 Posts
The page is blank.

"Tanker" usually refers to "M1 Tanker" which uses a M1, not M14 receiver. Short barrelled M14 is much easier to produce since the op rod is straight (the part under the barrel).

-- Chuck
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top