Recently bought a SOCOM and a TA01B. What mount are you all using for a 4*32 ACOG?

Hello everyone , new member here. I need your help in choosing the best carry handle mount. By the research i have already done i came down to these two brands. 1) SMITH ENTERPRISE 2) ARMS Which one of the two would you choose and why? If you know any other brands that are equally good or...

I bought a scope mount for my M1A many years ago (I don't even remember who made it, as there is no company marking that I can see). Unfortunately, I have lost the rear screw that mounts to the stripper clip guide (if that's the correct term for it). What is the name of this screw? I'd like...

I could go with a receiver mount but wanted to try the front rail system too. I have a picatinny extension in, and a cantilever mount for my crossfire II 2x7 scout scope. it feels sturdy enough, and my sight picture with my cheek riser is perfect. Want to hear other recommendations / advice

I have a SAI Scout. I mounted a CASM Gen II mount after having no luck zeroing the SAI mount. I tought the SAI mount looked crooked, but figured it was just because I was new to this platform. Now that I put the CASM mount on, if I look down the mount it's way left of the front sight. Today at...

I've been searching high and low and I'm just not finding a definitive answer to my question about 1903 scope bases and mounts. I have a Remington 1903 that has been drilled and tapped and I am working on turning it into as close to an A4 clone as I can. I'm basically down to finding the right...

I'm tossing my SA Scout into a sage chassis and was looking for the best possible scope mount. I've just looked at the sage mount really, and price isn't an issue.

ROE #8, New Topics Post new threads in the appropriate section of the community. Do not post the same discussion topic more than once in several areas of the forum. DISHOUT

For Christmas, I received a Vortex strikefire scope and 3x magnifier. Will this setup work with my SOCOM 16 if I get say an ARMS 18 mount? Or will there still be eye relief issues? Also as the magnifier only works with a high mount, is this going to make such a cheek weld issue that would I be...

I just installed my sadlak airborne scope mount today and the procedure was fairly straightforward after having read a few posts here and following the instructions word for word with a inch-pound torque wrench. One question did arise after i finished the installation however. While following...